How to Solve Carriage Problems with your HP DeskJet Printer

The carriage in a printer is the critical component that moves forward and backward to print your pages. It can jam, triggering the printer to misprint, seem broken or stop printing at all. If it happens with your HP DeskJet wireless printer, it will make the grinding noise while tries to slide but are unable to do this. It notifies that the actuator arm is jammed, which stops the carriage from sliding back and forth as it usually should. To fix the carriage issues without any hassles, you can call on the HP wireless printer customer support number.

How to Resolve the Carriage Issues with an HP DeskJet Wireless Printer

Solving the problem is only a way of raising and releasing the actuator arm, and then stirring the carriage again. You can examine the following steps to fix your printer’s carriage problems.

Step 1 – Remove the power cable of your printer from the wall outlet and raise its lid to open it so that you can check the carriage assembly. Remove the paper jam that may present. Get rid of excess paper from the print rollers.

Step 2 – Clasp the two handles at opposite ends of the tray and pull it out. Put the printer tray on the side. Search for the crumpled or jammed paper where the paper tray is set and remove the stuck pages. Gently shift the carriage to the center of your printer. If the carriage resists, stop here and go to the next step.

Step 3 – Find the long back bar located just up the rollers. Push the bar down and let it appear back. Try to move the carriage to the center again. If the carriage still struggles to move, desist and go to the step 4.

Step 4 – Find the black bar that assembles under the print rollers. You should check under and locate the bar. Check to ensure that it is smooth and parallel to your printer. Press it down gradually if it’s facing upward. Move the carriage to the center of your printer.

Step 5 – Raise the actuator arm that is a thin plastic strip beyond the gear assembly on the left corner inside your printer. Allow the arm to set back to its usual place.

Step 6 – Change the paper tray, and then connect your HP printer to the electrical outlet. Power it on and close the lid. Let your printer reset and press the ‘OK’ button on your printer control panel, or continue with the reset instructions displayed on the printer screen or given in the user’s manual.

If you’re not able to solve carriage issues with your HP printer using the troubleshooting steps as mentioned above, then instantly call the techies to fix the problems as immediately as possible and get your printer back in functioning. For the instant support, you can give the call to the HP wireless printer customer service number to get immediate technical support and solutions.